Inspectin Procedure: P0097 And P0098; I - Hino Motors HINO 155 series Workshop Manual

INSPECTION PROCEDURE: P0097 and P0098
1
Inspect the intake air temperature sensor (intake manifold) connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
2
Inspect the intake air temperature sensor (intake manifold)
Was any failure found?
Remove all contaminants and clogging.
Replace if damaged.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Check the connection of the intake air temperature sensor (intake
manifold) connector (looseness and poor contact).
YES
1. Check the installation of the intake air temperature sensor (intake
manifold).
2. Make sure there is no dirt, damage or clogging in the sensing unit
of the intake air temperature sensor (intake manifold).
YES
NO
Go to step 2.
NO
Go to step 3.
2–191