2–250
5
Inspect for short-circuit of the engine coolant temperature sensor harness
D
E66
Do the measurements meet the standard value?
Go to step 6.
6
Inspect disconnection of the engine coolant temperature sensor harness
D
E66
Do the measurements meet the standard value?
Go to step 7.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU. (Do not con-
E58
nect the harness to the ECU.)
3.
Use the electrical tester to measure the resistance between the
terminals of the engine ECU (signal check harness) and ground.
SHTS021270300228
Starter key: LOCK
YES
1.
Connect the engine coolant temperature sensor connector.
2.
Use the electrical tester to measure the resistance between the
E58
terminals of the engine ECU (signal check harness).
Starter key: LOCK
SHTS021270300229
YES
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
THW (E66) –
Ground
E5 (E58) – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
THW (E66) –
E5 (E58)
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
NO
Standard values
20 C {68 F}:
2.59 – 2.32 k
80 C {176 F}:
0.326 – 0.310 k
NO