Hino Motors HINO 155 series Workshop Manual page 127

6
Check harness in CAN bus line between DLC and J/C_CAN1 (22P) (Failure Site 1)
+24V CAN- TC
K9G KS4 KS2
ISOK CAN+ SGND CGFR
K9E KS3 K9H L30
Do the measurements meet the standard value?
Go to step 7.
ENGINE (J05E)/TROUBLESHOOTING
1. Use the electrical tester to measure the resistance between the
DLC CAN H line terminal and L line terminal.
DSW
KPZ
+
KE4
Starter key: LOCK
SHTS021270300078
YES
Measurement Tester
conditions connections
DLC: 6th – 14th
CAN bus line disconnection between DLC
and J/C_CAN1 (22P)
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
2–91
Standard values
45 – 75 
NO