Check The Power Supply Of Boost Pressure Sensor - Hino Motors HINO 155 series Workshop Manual

2–662
3

Check the power supply of boost pressure sensor

E
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Disconnect the boost pressure sensor connector.
VC
3. Set the starter key to the "ON" position.
4. Use the electrical tester to measure the voltage between the termi-
nals of the boost pressure sensor connector.
SHTS021270300604
YES
Measurement
conditions connections
Boost pressure
sensor vehicle
Starter key: ON
side connector
VC – E
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Tester
Standard values
4.5 – 5.5 V
NO