INSPECTION PROCEDURE: P0112 and P0113
1
Inspect the intake air temperature sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
2
Inspect the intake air temperature sensor
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the intake air tempera-
ture sensor.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Check the connection of the intake air temperature sensor (air flow
sensor) connector (looseness and poor contact).
YES
1.
Check the installation of the intake air temperature sensor (air flow
sensor).
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the intake air temperature sensor
YES
NO
Go to step 2.
NO
Go to step 3.
2–231