3
Check the VNT controller power supply circuit
GND
+B
Do the measurements meet the standard value?
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the VNT controller connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the VNT controller vehicle side connector.
SHTS021270300136
Starter key: ON
YES
Measurement
Tester
conditions
connections
VNT controller
vehicle side con-
nector
+B – GND
Check the VNT controller power supply cir-
cuit.
Perform "After-inspection work" of INFOR-
MATION section.
2–145
Standard values
8 V or more
NO