Inspect Disconnection Of The Engine Speed Sub Sensor Harness - Hino Motors HINO 155 series Workshop Manual

4
Inspect disconnection of the engine speed sub sensor (camshaft position sensor) harness
E54
D
E73
E53
G1
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1. Use the electrical tester to measure the resistance between the
terminals of the engine ECU (signal check harness) and engine
speed sub sensor (camshaft position sensor) vehicle side connec-
G-
tor.
VG
SHTS021270300421
Starter key: LOCK
YES
Measurement Tester
conditions connections
Engine speed sub
sensor (camshaft
position sensor)
vehicle side con-
nector – Engine
ECU (signal check
harness)
VC – VCG (E53)
G- – G- (E54)
G1 – G+ (E73)
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–457
Standard values
Less than 2 
NO