Check The Glow Light Circuit - Hino Motors HINO 155 series Workshop Manual

2–464
3

Check the glow light circuit

V7
A
Do the measurements meet the standard value?
Go to step 6.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Connect the signal check harness to the engine ECU.
B
V80
3. Use the electrical tester to measure the voltage between the termi-
nals of the engine ECU (signal check harness).
Starter key:
SHTS021270300427
ON/LOCK
YES
Measurement Tester
conditions connections
Engine ECU (sig-
nal check har-
ness)
GIND (V7) – GLW-
(V80)
Go to step 4.
Standard values
Starter key ON:
10 V or more
Starter key LOCK:
Less than 7 V
NO