Short-Circuits In Wire Harness Of Intake Throttle Valve Pos. Sensor 2 - Hino Motors HINO 155 series Workshop Manual

6
Inspect for short-circuits in wire harness of intake throttle valve position sensor 2
C
E33
E46
D
Do the measurements meet the standard value?
Go to step 7.
ENGINE (J05E)/TROUBLESHOOTING
1. Connect the signal check harness to the engine ECU vehicle side
harness. (Do not connect the harness to the ECU.)
2. Use the electrical tester to measure the resistance between the
terminals of the engine ECU (signal check harness) and ground.
E57
Starter key: LOCK
SHTS021270300335
YES
Measurement Tester
conditions connections
Engine ECU (sig-
nal check har-
ness)
VC2 (E33) –
Ground
VTA2 (E46) –
Ground
E3 (E57) – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–373
Standard values
 
NO