3
Inspect the EGR valve power supply
+B
E
Do the measurements meet the standard value?
Replace the EGR valve, go to step 4.
4
Check the DTC detected 2 (Engine ECU)
Has DTC P14B2 been detected?
Replace the engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the EGR valve connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the EGR valve vehicle side connector.
SHTS021270300711
Starter key: ON
YES
1.
Set the starter key to the "ON" position.
2.
Select [Engine] and check if P14B2 has been detected.
SHTS021270300712
YES
Measurement
Tester
conditions
connections
EGR valve vehicle
side connector
+B – E
Check the wire harness (actuator power sup-
ply and ground) and battery voltage.
Repair or replace parts as needed.
Perform "After-inspection work" of INFOR-
MATION section.
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.
2–787
Standard values
10 – 16 V
NO
NO