INSPECTION PROCEDURE: P0005
Check the DTC detected [HINO DX Ⅱ ]
1
Is any DTC other than P0005 detected?
Go to the relevant DTC-specific trouble-
shooting.
2
Inspect the power supply for the fuel cut valve
Do the measurements meet the standard value?
Go to step 3.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
Connect the diagnostic system (HINO DX Ⅱ ) to the vehicle.
2.
3.
Set the starter key to the "ON" position.
4.
On the screen of the diagnostic system, select [Engine], and check
any DTC listed below other than P0005.
- P0006, P0007, P016F
SHTS021270300097
YES
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the connector from the fuel cut valve.
BODY GND
3.
Set the starter key to the "ON" position.
4.
Using the electrical tester, measure the pressure between the fuel
cut valve vehicle side connector FCV terminal and ground.
SHTS021270300098
Starter key: LOCK
YES
Go to step 2.
Measurement
Tester
conditions
connections
Fuel cut valve
vehicle side con-
nector FCV termi-
nal –Ground
Inspect the power supply circuit of the
engine ECU.
2–105
NO
Standard values
8 V or more
NO