2–56
4
Check harness in CAN bus line between J/C_ENG_CAN2 and J/C_ENG_CAN (Failure Site 8)
1
2
3
4
%KH
%KF
%KE
%KG
6
7
%KM
%KL
Do the measurements meet the standard value?
Connect the J/C_ENG_CAN2 connector, and
go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1.
Disconnect the J/C_ENG_CAN2 connector.
2.
Use electrical tester to measure the resistance between No.5
(CANH)
C_ENG_CAN2 connector.
Starter key: LOCK
SHTS021270300035
YES
terminal
and
No.8
Measurement
Tester
conditions
connections
J/C_ENG_CAN2
connector
No.5 (CANH) –
No.8 (CANL)
CAN bus line disconnection between J/
C_ENG_CAN2 and the J/C_ENG_CAN
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
(CANL)
terminal
at
the
Standard values
110 – 130
NO
J/