Inspect Disconnection Of Wire Harness Of Starter Key "Start" Signal - Hino Motors HINO 155 series Workshop Manual

4
Inspect disconnection of the wire harness of the starter key "Start" signal
A
V12
6
#6
Do the measurements meet the standard value?
Inspect the starter key "Start" circuit.
(Neutral start switch – starter key)
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Use the electrical tester to measure the resistance between the
engine ECU (signal check harness) and the #6 terminals in neutral
start switch vehicle side connector.
Starter key: LOCK
SHTS021270300579
YES
Measurement Tester
conditions connections
Engine ECU (sig-
nal check har-
ness) – Neutral
start switch vehi-
cle side connector
ST (V12) – #6
Repair or replace the harness.
(Engine ECU – Neutral start switch)
Perform "After-inspection work" of INFOR-
MATION section.
2–635
Standard values
Less than 1 
NO