Inspect The Sensor Power Supply 1 - Hino Motors HINO 155 series Workshop Manual

3

Inspect the sensor power supply 1

G- VG
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1. Disconnect the engine speed sub sensor (camshaft position sen-
sor) connector.
2. Set the starter key to the "ON" position.
3. Use the electrical tester to measure the voltage between the termi-
nals of the engine speed sub sensor (camshaft position sensor)
vehicle side connector.
SHTS021270300416
Starter key: ON
YES
Measurement Tester
conditions connections
Engine speed sub
sensor (camshaft
position sensor)
vehicle side con-
nector
G- – VG
Go to step 4.
2–451
Standard values
4.5 – 5.5 V
NO