2–458
5
Inspect the engine speed sub sensor (camshaft position sensor) power supply
G-
VG
Do the measurements meet the standard value?
Go to step 6.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the engine speed sub sensor (camshaft position sensor)
vehicle side connector.
SHTS021270300422
Starter key: LOCK
YES
Measurement
Tester
conditions
connections
Engine speed sub
sensor (camshaft
position sensor)
vehicle side con-
nector
G- – VG
Replace the engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
4.5 – 5.5 V
NO