4
Check the power supply of intake throttle valve position sensor
VC
E2
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the intake throttle valve position sensor connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the intake throttle valve position sensor connector.
SHTS021270300605
Starter key: ON
YES
Measurement
Tester
conditions
connections
Intake throttle
valve position
sensor vehicle
side connector
VC – E2
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–663
Standard values
4.5 – 5.5 V
NO