Inspect The Engine Speed Main Sensor Power Supply - Hino Motors HINO 155 series Workshop Manual

2–444
3
Inspect the engine speed main sensor (crankshaft position sensor) power supply
NE+
Do the measurements meet the standard value?
Go to step 6.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Disconnect the engine speed main sensor (crankshaft position
NE-
sensor) connector.
3. Set the starter key to the "ON" position.
4. Use the electrical tester to measure the voltage between the termi-
nals of the engine speed main sensor (crankshaft position sensor)
vehicle side connector.
SHTS021270300409
Starter key: ON
YES
Measurement Tester
conditions connections
Engine speed
main sensor
(crankshaft posi-
tion sensor) vehi-
cle side connector
NE+ – NE-
Go to step 4.
Standard values
4.5 – 5.5 V
NO