2–360
INSPECTION PROCEDURE: P0219
1
Inspect the engine oil level.
Engine damage will occur.
Rivet
FULL
Gauge end
Is the engine oil quantity within the standard value?
Go to step 2.
2
Inspect the engine speed main sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Oil level gauge
ADD
Preferred level
SHTS021270300323
YES
1.
YES
Check the oil level gauge and make sure the engine oil quantity is
within the standard value.
Adjust the engine oil quantity according to
the standard value.
Perform "After-inspection work" of INFOR-
MATION section.
Check the connection of the engine speed main sensor connector
(looseness and poor contact).
Go to step 3.
NO
NO