INSPECTION PROCEDURE: P0016
1
Inspect the camshaft gear
Was any failure found?
Assemble the camshaft gear properly.
2
Inspect the flywheel
Was any failure found?
Assemble the flywheel normally.
3
Inspect engine speed main sensor (crankshaft position sensor), engine speed sub sensor
(camshaft position sensor)
Was any failure found?
Install the engine speed main sensor (crank-
shaft position sensor) and the engine speed
sub sensor (camshaft position sensor) in
proper locations.
ENGINE (J05E)/TROUBLESHOOTING
1.
Check that the camshaft gear is properly assembled.
YES
1.
Check that the flywheel is properly assembled.
YES
1.
Check that the engine speed main sensor (crankshaft position
sensor) engine speed sub sensor (camshaft position sensor) are
installed to the proper position.
YES
NO
Go to step 2.
NO
Go to step 3.
NO
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.
2–115