2–664
5
Check the power supply of engine speed sub sensor (camshaft position sensor)
G-
VG
Do the measurements meet the standard value?
Go to step 6.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the engine speed sub sensor (camshaft position sen-
sor) connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the engine speed sub sensor (camshaft position sensor)
connector.
SHTS021270300606
Starter key: ON
YES
Measurement
Tester
conditions
connections
Engine speed sub
sensor (camshaft
position sensor)
vehicle side con-
nector
VG – G-
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
4.5 – 5.5 V
NO