P081B: Starter Disable Circuit High; Dtc: P081B - Hino Motors HINO 155 series Workshop Manual

2–726

DTC: P081B

P081B: Starter Disable Circuit High

INFORMATION
+B
+B
ST
Ignition switch Neutral start switch
1. Technical description
• The starter block relay prevents further rotations of the starter when the starter key is turned after start of the
engine.
<Description of malfunction>
• Harness +B short-circuit is detected.
2. DTC set condition
(1) DTC detection condition
• Request for deactivation of starter block is in progress (while engine is stopped).
• Starter key "ON".
• Battery voltage is 10 V – 16 V.
Above conditions continue for at least 5 seconds.
(2) Judgement criteria
• Output of the starter block relay remains at 10 V or more for 3 seconds or longer.
3. Reset condition
• After restoration to normal condition
4. Indication, warning or system control regulation when the DTC is set.
• MIL: OFF
• SVS light: OFF
5. Symptoms on the vehicle when the DTC is set
<Symptoms on the vehicle due to backup control (fail safe function)>
• –
<Symptoms on the vehicle due to malfunction>
• Starter may not turn over. (If the starter turns over it will not interfere with engine operation.)
6. Pre-inspection work
• Check that the battery voltage is in the normal range.
7. After-inspection work
• Clear all past DTCs.
• Check that no DTC is stored after test drive.
ENGINE (J05E)/TROUBLESHOOTING
ST1 STA
Engine
ECU
+B
Starter relay
Fuse
+ST
STCR
Starter cut relay
EN01H02127030602016119
To starter
SHTS021270300664