Handling Of Electronic Parts; Handling Of Wire Harness - Hino Motors HINO 155 series Workshop Manual

1–14 GENERAL INTRODUCTION/SAFETY INSTRUCTIONS AND READINESS TO WORK
(2)

Handling of electronic parts

a. Never give an impact to electronic parts of a computer or relay.
b. Keep electronic parts away from high temperatures and humidity.
c. Never splash water onto electronic parts in washing the vehicle.
d. Do not remove the harness connector, electric component box, and cover except for repair and inspection.
If removal is necessary, pay attention that water and foreign matters do not attach or enter to the connector,
terminals, electric component box, and cover.
In restoration, make sure there is no attachment or entry of water and foreign matters and mount them prop-
erly, because it causes degradation of waterproof function.
(3)

Handling of wire harness

a. Perform marking on a clamp and a clip and secure then in original position so that the wire harness will not
interfere with the end and acute angle section of the body and a bolt.
b. To attach a part, take care not to bite the wire harness.
Incorrect
Incorrect
Incorrect
Incorrect
SHTS01ZZZ0300015
SHTS01ZZZ0300016