Check operation of VNT controller [HINO DX Ⅱ ]
3
Has DTC P062F been detected?
Replace the VNT controller.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "ON" position.
Erase the trouble history using HINO DX Ⅱ .
2.
3.
Set the starter key to the "OFF" position.
4.
Set the starter key to the "ON" position again.
5.
Select [Engine] and check if P062F has been detected.
HINT
Set the starter key "LOCK" and "ON" verifies the wiping operation
of the VNT actuator (DC motor).
SHTS021270300589
Starter key: LOCK ON
YES
Measurement conditions
NO
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.
2–647