2–722
INSPECTION PROCEDURE: P081A
1
Check the DTC detected (Engine ECU)
Has DTC P081A been detected?
Go to step 2.
2
Inspect the starter cut relay connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the starter cut relay.
3.
Set the starter key to the "ON" position.
4.
Select [Engine] and check if P081A has been detected.
SHTS021270300659
YES
1.
Check the connection of the starter cut relay connector (looseness
and poor contact).
YES
NO
Replace the starter cut relay.
Perform "After-inspection work" of INFOR-
MATION section.
NO
Go to step 3.