Inspect Disconnection Of The Common Rail Pressure Sensor Harness - Hino Motors HINO 155 series Workshop Manual

7

Inspect disconnection of the common rail pressure sensor harness

C
E33
D
E65
E64
Do the measurements meet the standard value?
Go to step 8.
ENGINE (J05E)/TROUBLESHOOTING
1. Connect the connector of the common rail pressure sensor.
D
2. Connect the signal check harness to the engine ECU vehicle side
E76
harness. (Do not connect the harness to the ECU.)
3. Use the electrical tester to measure the resistance between the
terminals of the engine ECU (signal check harness).
E76
Starter key: LOCK
SHTS021270300295
YES
Measurement Tester
conditions connections
Engine ECU (sig-
nal check har-
ness)
VC2 (E33) –
E2 (E76)
PCR2 (E64) –
E2 (E76)
PC2S (E65) –
E2 (E76)
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–329
Standard values
2  or more
NO