Hino Motors HINO 155 series Workshop Manual page 169

Check the connector connection [HINO DX Ⅱ ]
3
Has DTC P0047 been detected?
Go to step 4.
Check the operation of the VNT controller [HINO DX Ⅱ ]
4
Has DTC P0047 been detected?
Replace the VNT controller.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Disconnect the VNT actuator and VNT controller connector and
connect properly again.
3. Set the starter key to the "ON" position.
4. Select [Engine] and check if P0047 has been detected.
YES
1. Set the starter key to the "ON" position.
Erase the trouble history using HINO DX Ⅱ .
2.
3. Set the starter key to the "LOCK" position.
4. Set the starter key to the "ON" position again.
5. Select [Engine] and check if P0047 has been detected.
HINT
Turning the switch LOCK and ON verifies the wiping operation of
the VNT actuator (DC motor).
SHTS021270300124
Starter key: LOCK  ON
YES
NO
Procedure completed.
(Connector connection is faulty.)
Perform "After-inspection work" of INFOR-
MATION section.
Measurement conditions
NO
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.
2–133