Hino Motors HINO 155 series Workshop Manual page 802

2–766
4
Inspect the differential pressure sensor unit
VC
PEX
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1.
PEX
2.
3.
E2
SHTS021270300693
YES
Set the starter key to the "LOCK" position.
Disconnect the differential pressure sensor connector.
Use the electrical tester to measure the resistance between the
terminals of the differential pressure sensor.
Measurement
conditions connections
Differential pres-
sure sensor con-
Starter key: LOCK nector
VC – PEX
PEX – E2
Replace the differential pressure sensor.
Perform "After-inspection work" of INFOR-
MATION section.
Tester
Standard values
2 – 15 k
NO