3
Inspect the exhaust gas temperature sensor (DOC1 inlet) unit
GND
TOIL
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the exhaust gas temperature sensor (DOC1 inlet) con-
nector.
3.
Use the electrical tester to measure the resistance between the
terminals of the exhaust gas temperature sensor (DOC1 inlet).
SHTS021270300545
Starter key: LOCK
YES
Measurement
Tester
conditions
connections
Exhaust gas tem-
perature sensor
(DOC1 inlet)
TOIL – GND
Replace the exhaust gas temperature sensor
(DOC1 inlet).
Perform "After-inspection work" of INFOR-
MATION section.
2–597
Standard values
20 C {68 F}:
15.4 – 25.9 k
50 C {122 F}:
7.9 – 12.2 k
80 C {176 F}:
4.5 – 6.5 k
NO