INSPECTION PROCEDURE: P0106
1
Inspect the boost pressure sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
2
Inspect the boost pressure sensor
Was any failure found?
Clean the sensing unit and install it properly.
If dirt, clogging or damage was found,
replace the boost pressure sensor.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Check the connection of the boost pressure sensor connector
(looseness and poor contact).
YES
1.
Check the installation of the boost pressure sensor.
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the boost pressure sensor.
3.
Make sure there is no dirt, damage or clogging in the pipes or
hoses unit of the boost pressure sensor.
YES
NO
Go to step 2.
NO
Go to step 3.
2–217