INSPECTION PROCEDURE: P0652
1
Check the DTC detected 1 (Engine ECU)
Has DTC P0652 been detected?
After connecting the connector, go to step 2.
2
Check the DTC detected 2 (Engine ECU)
Has DTC P0652 been detected?
After connecting the connector, go to step 3.
ENGINE (J05E)/TROUBLESHOOTING
Connect the vehicle to HINO DX Ⅱ .
1.
2.
Erase the trouble history and set the starter key to the "LOCK"
position.
3.
Disconnect the common rail pressure sensor 2 (sub) connector.
4.
Set the starter key to the "ON" position.
5.
Select [Engine] and check if P0652 has been detected.
SHTS021270300614
YES
1.
Erase the trouble history and set the starter key to the "LOCK"
position.
2.
Disconnect the accelerator sensor 1 connector.
3.
Set the starter key to the "ON" position.
4.
Select [Engine] and check if P0652 has been detected.
SHTS021270300615
YES
NO
Replace the common rail pressure sensor 2
(sub).
Perform "After-inspection work" of INFOR-
MATION section.
NO
Replace the accelerator sensor 1.
Perform "After-inspection work" of INFOR-
MATION section.
2–673