Inspection Procedure: P0504; Inspect The Brake Switch Connector; Inspect The Brake Switch - Hino Motors HINO 155 series Workshop Manual

INSPECTION PROCEDURE: P0504

1

Inspect the brake switch connector

Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
2

Inspect the brake switch

Was any failure found?
Adjust the brake switch so that it is correctly
installed.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1. Check the connection of the brake switch connector (looseness
and poor contact).
YES
1. Check the installation of the brake switch.
2. Check if the brake switch is properly adjusted.
YES
NO
Go to step 2.
NO
Go to step 3.
2–571