3
Inspect for short-circuit in wire harness of suction control valve
SCV+
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the engine ECU connector.
SCV-
3.
Use the electrical tester to measure the resistance between the
suction control valve vehicle side connector terminals and ground.
Starter key: LOCK
SHTS021270300583
YES
Measurement
Tester
conditions
connections
Suction control
valve vehicle side
connector
SCV+ – Ground
SCV- – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–641
Standard values
NO