2–568
4
Inspect for disconnection in wire harness of vehicle speed signal circuit
V14
SPD2
Do the measurements meet the standard value?
Replace the combination meter.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Use the electrical tester to measure the resistance between the
combination meter vehicle side connector terminal and engine
A
ECU (signal check harness) terminal.
Starter key: LOCK
SHTS021270300519
YES
Measurement
Tester
conditions
connections
Combination
meter vehicle side
connector –
engine ECU (sig-
nal check har-
ness)
SPD2 – V14 (SP1)
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
Less than 1
NO