3
Inspect for short-circuits in wire harness of vehicle speed signal circuit
A
V14
GROUND
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the combination meter connector.
3.
Connect the signal check harness to the engine ECU vehicle side
harness. (Do not connect the harness to the ECU.)
4.
Use the electrical tester to measure the resistance between the
engine ECU (signal check harness) and ground.
SHTS021270300518
Starter key: LOCK
YES
Measurement
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness) – Ground
V14 (SP1) –
Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–567
Standard values
NO