Check Harness In Can Bus Line Between J/C_Hv2 And J/C_Hv1 - Hino Motors HINO 155 series Workshop Manual

2–64
3
Check harness in CAN bus line between J/C_HV2 and J/C_HV1 (Failure Site 10)
Do the measurements meet the standard value?
Connect the J/C_HV2 connector, and go to
step 4.
ENGINE (J05E)/TROUBLESHOOTING
1. Disconnect the J/C_HV2 connector.
2. Use electrical tester to measure the resistance between No.3
(CANH) terminal and No.8 (CANL) terminal at the J/C_HV2 con-
nector.
Starter key: LOCK
SHTS021270300045
YES
Measurement Tester
conditions connections
J/C_HV2 connec-
tor
No.3 (CANH) –
No.8 (CANL)
CAN bus line disconnection between J/
C_HV2 and the J/C_HV1
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
Standard values
110 – 130 
NO