Short-Circuits In Wire Harness Of Common Rail Pressure Sensor - Hino Motors HINO 155 series Workshop Manual

2–328
6
Inspect for short-circuits in wire harness of the common rail pressure sensor
GROUND
GROUND
Do the measurements meet the standard value?
Go to step 7.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
VC2
2. Disconnect the connector of the engine ECU.
3. Use the electrical tester to measure the resistance between the
common rail pressure sensor vehicle side connector terminals and
ground.
PCR2
Starter key: LOCK
SHTS021270300294
YES
Measurement Tester
conditions connections
Common rail pres-
sure sensor vehi-
cle side connector
VC2 – Ground
PCR2 – Ground
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
Standard values
 
NO