Check Harness In Can Bus Line Between J/C_Eng_Can And J/C_Can_Diesel - Hino Motors HINO 155 series Workshop Manual

3
Check harness in CAN bus line between J/C_ENG_CAN and J/C_CAN_Diesel (Failure Site 9)
Do the measurements meet the standard value?
Connect the J/C_ENG_CAN connector, and
go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1. Disconnect the J/C_ENG_CAN connector.
2. Use electrical tester to measure the resistance between No.6
(CANH) terminal and No.8 (CANL) terminal at the J/C_ENG_CAN
connector.
Starter key: LOCK
SHTS021270300034
YES
Measurement Tester
conditions connections
J/C_ENG_CAN
connector
No.6 (CANH) –
No.8 (CANL)
CAN bus line disconnection between J/
C_ENG_CAN and the J/C_CAN_Diesel
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
2–55
Standard values
110 – 130 
NO