Pto Installation Procedure; Gear Layout And Gear Ratio - Hino Motors 300 Series Mounting Manual

5 - 2 - 7

4) PTO Installation Procedure

(1) Drain the transmission oil.
(2) Remove the PTO cover which is at the left of the transmission.
(3) Clean the PTO mounting surface on the transmission side.
(4) Prepare the necessary parts, referring to paragraph "3")
(5) Install the stud bolts to the PTO mounting of the transmission
(6) Apply liquid gasket 'THREEBOND
(7) Fit the PTO on the PTO mounting position and tighten
(8) After attaching the PTO, turn the output shaft coupling a few
(9) When you refill the transmission oil, increase the amount by

5) Gear Layout and Gear Ratio

Gear ratio : i =N2/N1xN4/N3xN5/N4
Transmission N1 N2
MYY6S 26 47
[NOTES]
1. Number of revolutions of PTO output shaft
= number of revolutions of engine x1/ i
2. The PTO output shaft turns in the opposite direction to the engine.
(Do not remove the drain plug while the oil is hot, or you will
scaled yourself.)
( Do not reuse the bolts and gasket that you remove at this
time.)
case.
1215' or 'LOCKTITE 5127
(FMD-127)' to PTO sealing surface
of transmission case as shown.
Appling methods
1) Remove moisture and oils from
sealing surface before appling.
2) Dia of liquid gasket is 2 min.
3) Liquid gasket bead must be
continued all round.
nuts.
Tightening torque for nuts : 36.3N·m {370kgf·cm}
revolutions to be sure that it turns freely.
0.3 liters to allow for the PTO.
N3 N4 N5 i
33 31 27 1.479
AUSXZU201 05T015
KK-XZU215C