Inspect For Disconnection In Wire Harness Of Boost Pressure Sensor - Hino Motors HINO 155 series Workshop Manual

4

Inspect for disconnection in wire harness of boost pressure sensor

C
E33
PIM
E
D
E67
E77
Do the measurements meet the standard value?
Go to step 5.
ENGINE (J05E)/TROUBLESHOOTING
1. Use the electrical tester to measure the resistance between the
engine ECU (signal check harness) and boost pressure sensor
vehicle side connector terminals.
VC
Starter key: LOCK
SHTS021270300199
YES
Measurement Tester
conditions connections
Engine ECU (sig-
nal check har-
ness) – boost
pressure sensor
vehicle side con-
nector
VC2 (E33) – VC
PIM (E67) – PIM
E4 (E77) – E
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–219
Standard values
 
NO