P0610: Vin Data Error; Dtc: P0610 - Hino Motors HINO 155 series Workshop Manual

DTC: P0610

P0610: VIN data error

INFORMATION
1. Technical description
• Receipt of vehicle information (VIN) is detected.
<Description of malfunction>
• Vehicle information is not received or the wrong vehicle information is received.
2. DTC set condition
(1) DTC detection condition
• Starter key "ON".
• Battery voltage is in the range of 10 V to 16 V.
The conditions described above remain for 5 seconds or longer.
HINT
This DTC is detected when replacing the engine ECU and the VIN information from the vehicle control ECU has
not been received.
(2) Judgement criteria
• Engine ECU can not receive VIN information from the vehicle control ECU.
3. Reset condition
• After restoration to normal condition and starter key "LOCK"
4. Indication, warning or system control regulation when the DTC is set.
• MIL: OFF
• SVS light: ON
• Cruise control function is not available.
5. Symptoms on the vehicle when the DTC is set
<Symptoms on the vehicle due to backup control (fail safe function)>
• Cruise control does not work.
<Symptoms on the vehicle due to malfunction>
• –
6. Pre-inspection work
• Check that the battery voltage is in the normal range.
7. After-inspection work
• Clear all past DTCs.
• Check that no DTC is stored after test drive.
8. Estimated failure factors
• Vehicle control ECU failure
• Engine ECU failure
• Malfunction of vehicle power supply (noise)
• CAN circuit failure (noise)
ENGINE (J05E)/TROUBLESHOOTING
<Vehicle control ECU>
CAN communication
<Engine ECU>
2–627
EN01H02127030602016101
SHTS021270300570