5
Inspect for disconnection in the wire harness of the engine stop switch
Do the measurements meet the standard value?
Replace the engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
ENGINE (J05E)/TROUBLESHOOTING
1.
Set the starter key to the "LOCK" position.
2.
Use the electrical tester to measure the resistance between the
ESTP (V32) terminal in the engine ECU (signal check harness)
and terminals in the engine stop switch vehicle side connector.
Measurement
Starter key: LOCK
YES
Tester
conditions
connections
Engine ECU (sig-
nal check har-
ness)
ESTP (V32) –
Engine stop
switch vehicle
side connector
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
2–819
Standard values
Less than 1
NO