Hino Motors HINO 155 series Workshop Manual page 451

3
Inspect the boost pressure sensor power supply system
E
VC
Do the measurements meet the standard value?
Go to step 4.
ENGINE (J05E)/TROUBLESHOOTING
1. Set the starter key to the "LOCK" position.
2. Disconnect the boost pressure sensor connector.
3. Set the starter key to the "ON" position.
4. Use the electrical tester to measure the voltage between the termi-
nals of the boost pressure sensor vehicle side connector.
SHTS021270300378
Starter key: ON
YES
Measurement Tester
conditions connections
Boost pressure
sensor vehicle
side connector
VC – E
Inspect the harness and engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
2–415
Standard values
4.75 – 5.25 V
NO