Stacking Commands - D-Link xStackTM DGS-3300 User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
The stacking configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
config box_priority
config box_id
config box_type
config all_boxes_id
show stack_information
Each command is listed, in detail, in the following sections.
config box_priority
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To configure box priority:
DGS-3324SRi:4#config box_priority current_box_id 1 priority 1
Command: config box_priority current_box_id 1 priority 1
Success.
DGS-3324SRi:4#
Parameters
current_box_id <value 1-12> priority <value 1-16>
current_box_id <value 1-12> new_box_id [AUTO | 1 | 2 | 3 | 4 | 5
| 6 | 7 | 8 | 9 | 10 | 11 | 12]
current_box_id <value 1-12> type [DGS-3324SR | DXS-3350SR |
DXS-3326GSR | BOX_NOTEXIST]
[static_mode | auto_mode]
Used to configure box priority, which determines which box
becomes master. Lower numbers have higher priority.
config box_priority {current_box_id <value 1-12> priority
<value 1-16>}
This command configures box (switch) priority.
current_box_id <value 1-12> – Identifies the Switch being
configured. Range is 1-12.
priority <value 1-16> – Assigns a priority value to the box, with
lower numbers having higher priority. Range is 1-16.
Only administrator-level users can issue this command.
240
S C
TACKING
27
OMMANDS