Notation For Parameters - YASKAWA SGD7C-***AMAA*** Product Manual

5.1 Manipulating Parameters (Pn)

5.1.2 Notation for Parameters

5.1.2

Notation for Parameters

There are two types of notation used for parameters that depend on whether the parameter
requires a numeric setting (parameter for numeric setting) or requires the selection of a function
(parameter for selecting a function).
•
Parameters for Numeric Settings
Pn100
If "All Axe " i given
here, the parameter
applie to both axe A
and B.
If you change the
etting, the new etting
will be applied to both
axe .
Thi i the etting range for the parameter.
•
Parameters for Selecting Functions
Parameter
number
Pn00F
All Axe
If "All Axe " i given here, the parameter applie to both axe A and B.
If you change the etting, the new etting will be applied to both axe .
5-6
Parameter
number
peed Loop Gain
etting Range etting Unit
10 to 20,000 0.1 Hz
Thi i the minimum
unit ( etting increment)
that you can et for
the parameter.
Parameter
n. 0
Do not detect preventative maintenance warning .
(default etting)
n. 1
Detect preventative maintenance warning .
The notation "n. " indicate a parameter for
electing function . Each indicate the etting for
one digit. The notation hown here mean that the fir t
digit from the right i et to 1.
The control method for which the parameter apply are given.
: peed control
peed Po ition
Default etting
400
Thi i when any
Thi i the
change made to the
parameter etting
parameter will
et before
become effective.
hipment.
Meaning
Thi column explain the
election for the function.
: Po ition control
Torque : Torque control
peed Po ition
Cla ification
When Enabled
Tuning
Immediately
Thi i the parameter
cla ification.
When Enabled
After re tart
Cla ification
etup