Table of Contents
Advertisement
2.5 Monitoring the Installation Environment
2.5
Monitoring the Installation Environment
You can use the SERVOPACK Installation Environment Monitor parameter to check the operat-
ing conditions of the SERVOPACK in the installation environment.
You can access the SERVOPACK Installation Environment Monitor with the following menu
command on the SigmaWin+: Life Monitor − Installation Environment Monitor − SERVO-
PACK.
Implement one or more of the following actions if the monitor value exceeds 100%.
• Lower the surrounding temperature.
• Decrease the load.
Information
Important
2-6
The value of the SERVOPACK Installation Environment Monitor parameter will increase by
about 10% for each 10°C increase in the surrounding air temperature.
Always observe the surrounding air temperature given in the SERVOPACK environment condi-
tions. Even if the monitor value is 100% or lower, you cannot use a SERVOPACK in a location
that exceeds the specified surrounding air temperature.
Advertisement
Table of Contents
Troubleshooting
