Table of Contents
Advertisement
Link Assignment Tab Page
The Link Assignment Tab Page displays the assignment settings for all slave devices that were
detected during self-configuration (MECHATROLINK-connected devices, such as SERVO-
PACKs or distributed I/O).
Displayed Items
The following table lists the items that are displayed on the Link Assignment Tab Page.
For the valid setting ranges and setting precautions, refer to the descriptions of the items on
the following pages.
No.
Item
ST#
ADR
ExADR
VENDOR
DEVICE
PROFILE
BYTE
INPUT
OUTPUT
D
SIZE
11
SCAN
12
Station Name (comment)
13
Item Details
This section provides details on the items that are displayed on the Link Assignment Parame-
ters Tab Page.
Always save all settings to the flash memory after changing them.
Important
ST#
This is the station number.
The number of rows that is displayed corresponds to the number of slave stations that is set on
the Transmission Parameters Tab Page.
This number is automatically assigned.
4.3.3 Confirming the Detailed Definitions of the Function Modules
Displays the station number.
Sets the station address of the slave station.
Set the individual extended addresses when multi-station modules
(multi-slaves) are grouped together as a single node.
Set the vendor name of the device.
Sets the slave model.
Set the profile to use.
Sets the number of transmission bytes.
Sets the first register address of the input area.
Sets the first register address of the output area.
Enables or disables the I/O registers.
Set the input and output sizes in words.
Sets the scan in which the input or output is performed.
Used to enter a comment of up to 32 characters.
4.3 Self Configuration
11 11
11 11
12 12
Description
1 1
4
4-35
Advertisement
Table of Contents
Troubleshooting
