Selecting The Phase Sequence For A Linear Servomotor - YASKAWA SGD7C-***AMAA*** Product Manual

5.8 Selecting the Phase Sequence for a Linear Servomotor

5.8

Selecting the Phase Sequence for a Linear Servomotor

You must select the phase sequence of the Linear Servomotor so that the forward direction of
the Linear Servomotor is the same as the encoder's count-up direction.
Before you set the Linear Servomotor phase sequence (Pn080 = n.
items.
• Confirm that the signal from the linear encoder is being received normally.
• Make sure that the forward direction of the Linear Servomotor and the count-up direction of
the linear encoder are in the same direction.
Important
Related Parameters
Pn080
Operating Procedure
Use the following procedure to select the phase sequence for a Linear Servomotor.
1.
Set Pn000 to n.
This setting is to make following confirmation work easier to understand.
2.
Select Monitor in the Menu Dialog Box.
The Operation Pane will be displayed so that you can check the feedback pulse counter.
3.
Manually move the Moving Coil from one end to the other of the stroke and confirm that
only the correct number of feedback pulses is returned.
If the correct number and only the correct number of pulses is returned, the signal is being received
correctly from the linear encoder.
Example
Note: The actual monitor display will be offset by the error in the travel distance. There is no problem as long as the
above value is close to the calculated value.
5-22
If you do not confirm the above items before you attempt to operate the Servomotor, the Servo-
motor may not operate or it may run out of control. Always confirm these items before you oper-
ate the Servomotor.
Parameter
n.0
Set a phase-A lead as a phase sequence of U,
(default set-
V, and W.
ting)
Set a phase-B lead as a phase sequence of U,
n.1
V, and W.

0 (Set a phase-A lead as a phase sequence of U, V, and W).
In this example, assume that a linear encoder with a scale pitch of 20 μm and a resolu-
tion of 256 is used. If you manually move the Moving Coil 1 cm in the count-up direction
of the linear encoder, the number of feedback pulses would be as follows:
1 cm/(20 μm/256) = 128,000 pulses.
If there are 128,000 pul e on the feedback pul e counter after you manually move the Moving Coil
in the direction of the cable, you have completed the confirmation.
Meaning
Cable for Linear ervomotor Moving Coil
 
X ), check the following
When Enabled Classification
After restart Setup