Usb Memory; Operating Procedure - YASKAWA SGD7C-***AMAA*** Product Manual

12.2

USB Memory

You can transfer user application data between the RAM in the CPU and the USB memory
device.
Operation
Batch load
USB mem-
ory batch
transfer
Batch save
Data logging
Batch load
Import/
Export
instructions
Batch save
12.2.1

Operating Procedure

This section describes the procedures for loading all of the data from the USB memory device
and saving all of the data to the USB memory device.
Batch Loading from USB Memory Device
1.
Turn OFF the control power supply to the SERVOPACK.
2.
Insert the USB memory device that contains the application data to transfer into the
USB connector (CN10).
Information
3.
Turn ON only the LOAD pin on the DIP switch (mode switch).
4.
Set the INIT pin on the DIP switch (mode switch) according to the register type to load.
Registers to
Load
M Registers
G registers
S registers
I registers
O registers
C registers
# registers
D registers
Outline
Loads all of the user application data
that is saved in the USB memory
device to the CPU's non-volatile mem-
ory.
Saves all of the user application data
that is saved in the CPU's RAM to the
USB memory device.
Saves all of the logged data in the CPU
to the USB memory device.
Loads all of the user application data
that is saved in the USB memory
device to the CPU's RAM from within a
ladder program.
Saves all of user application data that is
saved in the CPU's RAM to the USB
memory device from within a ladder
program.
Make sure that the folder hierarchy and file naming where the application data is to be
stored is as shown below.
MP_BKUP
BACKUP
OFF
Transferred.
Not transferred regardless of INIT pin setting.
Always transferred regardless of INIT pin setting.
Batch Loading from USB Memory Device
on page 12-17
Batch Saving to USB Memory on page 12-
18
12.3 File Transfer on page 12-20
MP3000 Series Ladder Programming
Manual (Manual No.: SIEP C880725 13)
INIT Pin Setting
ON
Not transferred.
12.2 USB Memory
12.2.1 Operating Procedure
Reference
12-17
12