Connecting The Other Connectors; Computer Connector (Cn7); Usb Connector (Cn10) - YASKAWA SGD7C-***AMAA*** Product Manual

3.9

Connecting the Other Connectors

3.9.1

Computer Connector (CN7)

To use the SigmaWin+ Engineering Tool, connect the computer on which the SigmaWin+ is
installed to CN7 on the SERVOPACK.
Refer to the following manual for the operating procedures for the SigmaWin+.
AC Servo Drive Engineering Tool SigmaWin+ Operation Manual (Manual No.: SIET S800001 34)
Use the cable specified by Yaskawa. If you use any other cable, noise resistance may be low and
normal operation may not be possible.
Important
3.9.2

USB Connector (CN10)

To use a USB memory device, connect the USB memory device to CN10 on the SERVOPACK.
Connecting a USB Memory Device to the USB Connector
This section describes how to insert and remove a USB memory device.
 Inserting a USB Memory Device
1.
Open the USB connector cover.
With the Cover Open
2.
Insert the USB memory device into the USB connector.
Confirm that the USB ACTIVE indicator lights.
Refer to the following section for details on the USB status indicator.

USB Status Indicator on page 1-32
U B connector

3.9 Connecting the Other Connectors

3.9.1 Computer Connector (CN7)

3
3-45