Table of Contents
Advertisement
• DWG.A, DWG.I, and DWG.L drawings do not have operation mode settings.
Example
Information
• The more often the following instructions are used, the greater the effect that the optimiza-
tion will have on DWG.H processing.
Relay Circuit Instructions
Numeric Operation
Instructions
Perform the following procedure with MPE720 to set the high-speed drawing operation mode.
Select File − Environment Settings from the menu bar. Alternatively, click the System
1.
Setting Button on the My Tool View of the Start Tab Page. The Environment Setting Dia-
log Box is displayed.
Select Setup − System Setting. The following dialog box will be displayed.
2.
3.
Select High-Speed or Normal in the High-Speed Drawing Operation Mode Box.
Type
Rising-edge NO Contact
Falling-edge NO Contact
Rising-edge NC Contact
Falling-edge NC Contact
Rising-edge Pulse
Falling-edge Pulse
Coil
Reverse Coil
Rising-edge Detection Coil
Falling-edge Detection Coil
Set Coil
Reset Coil
Increment
Decrement
7.1 User Program Types and Execution Timing
Function
7.1.1 Ladder Programs
7-9
7
Advertisement
Table of Contents
Troubleshooting
